- Make sure your CDJ and DJM are switched on (rear control).
- Check that the CDJ audio outputs are connected to the DJM 'Line In' input (channel 2 and channel 3) using the red and white RCA cables.
- Set the DJM output channels to 'Line' mode.
- Set the 'Balance' knob to the center position (12h) for a balanced output level.
- Adjust the 'Trim' knob of each channel so that the signal does not exceed 0, to prevent distortion.
- Gradually increase the master to send sound to the fronts.
DJ: Start-up configuration for the CDJ-3000 and DJM set
#DJ #CDJ #DJM #Configuration #HowToStart
Super Administrator
Written By Van strydonck Damien (Super Administrator)
Updated at July 27th, 2024
Share Link